Burnning mSD card image
How to load Eunhasu image to the micro SD card.
Windows OS
Preparation
-
Download the
imageUSB utility and unzip.
Push the micro SD card slightly from the micro SD card slot on the rear panel of sMS-200 to take out, and insert it to the micro SD card reader. The micro SD card slot is “push-push type”, so after loading the image file to the micro SD card, you can insert the micro SD card back to the micro sd card slot. Once it's inserted well, then you can hear click sound.
Run imageUSB
Run imageUSB. The connected USB device will be shown up. If the connected USB device is not shown, click 'Refresh Drives'.
Select an USB device
Select an USB device to write the new image file.
Select the new image file
Click 'Browse' button and select the downloaded image file.
Write the new image
Click 'Write' button to write the new image file to the micro SD card.
Finish
Insert the micro SD card back to the micro sd card slot on the rear panel of the sMS-200 or sMS-200ultra.
Power on the device, and check the device works fine.
macOS
Preparation
-
Download dd-utility from
here or
github. And install it.
Eject the micro SD card from the rear panel of sMS-200 and insert it to a PC's USB port by using the micro SD card reader.
Start Restore
Click 'Restore' and select downloaded .img file.
Select mSD card.
And start.
You can see the progress.
After done the process above, insert the mSD card to the mSD card slot of the sMS-200 or sMS-200ultra rear panel.
You can also use command-line by terminal instead of dd utility. Refer to here.
Downloads
Utilities
micro SD card image files
If file name ended .gz or .zip, you need to extract by an utility.
If you are not able to complete the process successfully at the end of steps, please check this video, https://youtu.be/ty_HN2gqJtQ. A few unzip utilities can't unzip the file completely and the unzip process may need 2 times in the progress, the video was made by one of our valuable customer, and thanks to HC.