This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
en:eunhasu:installing_x86 [2019/02/27 18:44] – [Boot the sMS-1000SQ] admin | en:eunhasu:installing_x86 [2019/04/01 06:40] – [Eunhasu x86 image file] kkh | ||
---|---|---|---|
Line 26: | Line 26: | ||
- Hit F10 key to go to the booting disk selection screen. The F10 key should be hit at the same time when the unit is powered on. | - Hit F10 key to go to the booting disk selection screen. The F10 key should be hit at the same time when the unit is powered on. | ||
- Select the inserted USB installation disk and start booting the device. | - Select the inserted USB installation disk and start booting the device. | ||
+ | |||
+ | === If you change the OS from the Vortexbox or Windows Edition to Eunhasu OS === | ||
+ | |||
+ | * You will need to enable UEFI boot before installing Eunhasu OS newly. | ||
+ | |||
+ | - Please enter to BIOS setup by hitting F2 button once you power up the sMS-1000SQ. | ||
+ | - Go to Boot menu, and check UEFI boot is enabled. If it is disabled, please make it enabled. | ||
+ | - Go to Exit menu for Exit Saving Changes. | ||
+ | {{ : | ||
+ | {{ : | ||
=== If the boot disk selection screen is not shown up === | === If the boot disk selection screen is not shown up === | ||
Line 103: | Line 113: | ||
==== Eunhasu x86 image file ==== | ==== Eunhasu x86 image file ==== | ||
- | * [[http:// | + | * [[http:// |