This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| diretta [2026/03/26 23:23] – dbryu | diretta [2026/03/26 23:32] (current) – [Using a Windows PC as a Diretta Host] dbryu | ||
|---|---|---|---|
| Line 59: | Line 59: | ||
| - | * sMS-2000, sMS-1000SQ : supports MTU up to 9014 | + | |
| - | * sMS-200, sMS-200ultra : supports MTU up to 1500 | + | |
| ----- | ----- | ||
| Line 76: | Line 76: | ||
| 3. Click Save & Reboot to restart the system. | 3. Click Save & Reboot to restart the system. | ||
| - | 4. After rebooting, go to the Diretta Config page and configure the following: | + | 4. After rebooting, go to the Diretta Config page and configure the following : |
| - | * Diretta Target MTU : | + | * Diretta Target MTU : Set this to the same value as, or lower than, the MTU value configured in System Config. |
| - | Set this to the same value as, or lower than, the MTU value configured in System Config. | + | * Diretta External MTU : Set this to the same MTU value configured on the Diretta Host device (such as a PC or another Eunhasu device). |
| - | * Diretta External MTU : | + | |
| - | Set this to the same MTU value configured on the Diretta Host device (such as a PC or another Eunhasu device). | + | |
| 5. Complete the remaining Diretta settings, save the configuration, | 5. Complete the remaining Diretta settings, save the configuration, | ||
| Line 125: | Line 123: | ||
| 1. Open **Music Player Config**. | 1. Open **Music Player Config**. | ||
| - | 2. Select | + | 2. In the Audio Device section, select |
| + | (The device name will appear as a Diretta Target.) | ||
| 3. Click **Save Changes**. | 3. Click **Save Changes**. | ||
| Line 136: | Line 135: | ||
| ===== Using a Windows PC as a Diretta Host ===== | ===== Using a Windows PC as a Diretta Host ===== | ||
| - | Install the **Diretta | + | A Windows PC can be used as a Diretta |
| + | 1. Install the **Diretta ASIO driver**. | ||
| + | Download and install the Diretta ASIO driver on the Windows PC. | ||
| [[https:// | [[https:// | ||
| - | If using **MS Mode3**, install: | + | 2. Install Packet Capture Driver. (Optional) |
| + | Depending on the Diretta mode, a packet capture driver may be required. | ||
| + | Install one of the following : | ||
| * [[https:// | * [[https:// | ||
| * [[https:// | * [[https:// | ||
| - | Configure | + | This is required only when using specific Diretta modes such as MS Mode3. |
| + | |||
| + | 3. Configure the Diretta ASIO Driver. | ||
| + | After installation, | ||
| + | * Click the **Find** button. | ||
| + | * Select the Diretta Target device from the **Connect Target** list. | ||
| + | * Click **Save** to apply the configuration. | ||
| {{ : | {{ : | ||