sDP-1000, sDP-1000EX Battery Replacement Instruction

<note important>
**CAUTION**
  * If circumstances allow, ask your dealer for a replacement.
  * Be careful not to overtighten the screws.
  * Please recycle the used batteries as they have an explosion risk.
</note>

{{ :en:capture_20161117122958.png |}}
Remove the outer four Phillips screws carefully 

{{ :en:capture_20161117123010.png |}}
Remove the outer two connectors by pulling down. Leave the center connector alone.

{{ :en:capture_20161117123024.png |}}
  - Unscrew the four remaining screws on the battery holder plate.
  - Unwrap the nylon reinforced tape from the batteries and the back-plate.

{{ :en:capture_20161117123040.png |}}
Carefully pry the battery packs off the back plate using a tool such as a straight razor.

{{ :en:capture_20161117123056.png |}}
Remove residual tape on the back-plate.

{{ :en:capture_20161117123110.png |}}
Remove peels of tape from the new battery pack. Center it carefully on the two holes, making a little space between the two batteries.

{{ :en:capture_20161117123128.png |}}
Wrap batteries and back-plate with the provided nylon reinforced tape.

{{ :en:capture_20161117123140.png |}}
Screw the back-plate with batteries to the battery holder plate.

{{ :en:capture_20161117123157.png |}}
Hold the new battery pack at the angle like the image above, and plug the outer (battery) terminals in.

{{ :en:capture_20161117123211.png |}}
Screw the battery holder plate (outer four) screws in place, and make sure the foot is positioned in the lower and outside corner.