Requirement
Simple Instruction
Connect a Wifi USB dongle into on of the two USB port. To setup Wifi feature on Eunhasu, the wired LAN should be connected.
Click 'Wifi' tab in System config page.
Click 'Wifi Router' button to show Wireless Access Point and it will take a few minutes to be detected the AP.
Select AP what you want.
Enter password or secret if required.
Wait till the progress will be done.
After connecting successfully, you can see IP address like the screen shot below.
If you need to remove the Wifi connection information, Click 'Remove Wifi Information' button, it will remove all saved information including the name and password.
Eunhasu version >= V0.3.0 required.
There might be connection error if you use wired and wireless network at the same time.
Network speed could be degraded depends on wireless network status.
After connected wireless, use the IP address to be connected.
Reference
Video clip
Device IDs in driver
0x050D, 0x1106 : Belkin - sercomm
0x050D, 0x1109 : Belkin F9L1109 - SerComm
0x2001, 0x330E : D-Link - ALPHA
0x7392, 0xA822 : Edimax - Edimax
0x0DF6, 0x0074 : Sitecom - Edimax
0x04BB, 0x0952 : I-O DATA - Edimax
0x0789, 0x016E : Logitec - Edimax
0x0409, 0x0408 : NEC -
0x0B05, 0x17D2 : ASUS - Edimax
0x0E66, 0x0022 : HAWKING - Edimax
0x0586, 0x3426 : ZyXEL -
0x2001, 0x3313 : D-Link - ALPHA
0x1058, 0x0632 : WD - Cybertan*/
0x13B1, 0x003F : Linksys WUSB6300
0x1740, 0x0100 : EnGenius - EnGenius
0x2019, 0xAB30 : Planex - Abocom
0x07B8, 0x8812 : Abocom - Abocom
0x2001, 0x3315 : D-Link - Cameo
0x2001, 0x3316 : D-Link - Cameo
0x20F4, 0x805B : TRENDnet - Cameo
0x2357, 0x0101 : TP-Link - Archer T4U
0x2357, 0x0103 : TP-Link - T4UH
0x2357, 0x010D : TP-Link - Archer T4U AC1300
0x2357, 0x010F : TP-Link - Archer T4UHP
0x148F, 0x9097 : Amped Wireless ACA1
Last Updated: 2023/01/27 00:12